Union TV Universal Remote Codes – How to Program

Union Tv Universal Remote Codes List: Are you trying to program your union tv remote along with your favorite universal remote, then here we are getting to mention all kinds of remote codes like 3 digits, 4 digits, and also 5 digit codes, you only got to use those codes from the below list and keep it up trying to program your tv with the universal remote. If one code doesn’t work then try with another code. First of all, we are giving the codes, then we will check the programming methods beneath the codes list. So keep it up trying until you get programmed with both the tv and remote. For almost most of the remotes, the below method is often working perfectly so once you are trying the below method with the above codes if it doesn’t work then follow the below alternative methods.

Union Tv Universal Remote Codes

Check alsoSamsung Soundbar Universal Remote Codes

union tv universal remote codes list and how to program

  • First of all, turn your tv on
  • Then “Hold” “TV and also SEL” buttons simultaneously for up to three seconds.
  • After that, the button is going to be “Blinking with a light
  • With that “Button light,” you would like to point the remote at the “TV” and then enter a “3 or 4 or 5 digit code
  • Now press the “Volume + button” to verify, then it should activate the quantity up.
  • Finally, press the “TV” button to store the codes, for confirmation check the button, it’ll blink twice.

Union TV Universal Remote 4 Digit Codes List

  • 2897, 2885, 2880

Union TV Universal Remote 3 Digit Codes List

  • 055, 060, 065, 067, 013, 054, 089

How to Program Union TV Universal Remote?

1) Keycode

By using the keycode we will easily program a Union TV universal remote and therefore the keycode identifies the make and model of your equipment.

  • First, you would like to “Turn The Device On
  • Press the “TV” on your “Union TV Universal Remote
  • Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
  • Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
  • Once you’ve done this procedure, just “point your remote at the TV” then “Press And Hold The Power” button
  • You can release the “Power Button” whenever the screen switches off

2) Programming Via Universal Union TV Remote Code

If you couldn’t find the key code which works for the device at that point you’ll found out your Union TV universal remote to look mode for the right one. Its a code within the manual that forces the remote into the search mode

  • First of all “Turn The Device On
  • Now press and hold the “Setup” button
  • Enter the “9-9-1” (three-digit) code
  • Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off

Check also: How to Watch Disney Plus On Nintendo Switch

3) Manual Setup

  • Place the “Remote Control facing To The Universal remote you would like to replace
  • Now press the “Setup Button” or “Magic
  • Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
  • Now press any of the functions which you would like to “program” as an example “TV Volume Up
  • Then press And hold the corresponding key on the “Original Remote Controller
  • Finally, one of the lights will “blink” meaning it’s been saved correctly
  • Now your “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.

We hope the above methods and therefore the codes are worked to program your Union TV and also for your favorite remote. Those methods are used for Union TV remote setup.

Leave a Comment