RCA Home Theater Universal Remote Codes List and Instruction guide

RCA Converter Box Remote Codes SanyoI need the GE Universal Remote codes I can not seem to urge the converter box to figure the red light on how do I reset the password on my RCA TV converter.

RCA Home Theater Universal Remote codes

rca home theater universal remote codes list

  • Install batteries into the Universal Remote.
  • Are you ready to point the Universal Remote at the TV or another device you’re trying to regulate during programming? If this “link” is broken, you’ll need to restart the programming process.

RCA Home Theater Audio Codes

  • 1254
  • 2154
  • 1913

RCA Home Theater Video Codes

  • 1022
  • 1060
  • 1132

RCA Home Theater Universal Remote 5 Digit Codes

  • 64257
  • 31254
  • 18192
  • 51472
  • 18704
  • 51216
  • 18448
  • 19216
  • 51728
  • 18960

The easiest thanks to program a Universal Remote is to enter a code that identifies the product you would like to regulate. Codes could also be provided via a “code sheet” or an internet page where the codes are listed by brand and sort of device (TV, Blu-ray Disc player, home theatre Receiver, Cable Box, VCRs, and sometimes media streamers).

  • Turn on the device you would like to regulate.
  • Press and hold the acceptable DEVICE button on your Universal remote (some remotes require that you simply press a Setup button before pressing the device button). The LEDs for the device and power buttons will illuminate.
  • With the device button on the remote held down, ENTER THE CODE for the brand of the device. If a brand has quite one code, start with the primary one. As you enter the code, the facility button on the remote will close up.
  • After entering a code, keep holding down the device button. If the control’s power button lights up and stays on, you’ve got entered the right code.
  • If the facility button blinks several times, then the code you entered isn’t correct. whenever you’re unsuccessful repeat the code entry step for every code until one works.

After programming, see if the universal remote controls the essential functions of your device. For a TV, you ought to be ready to turn it off and on, change the quantity, channel, and source input.

Auto Code Search

Auto Code Search is often used if you do not have access to the precise code for the brand or sort of device you would like to regulate. The Universal Remote will search through the whole list of codes it’s in its database, testing several codes at a time.

Here is an example of likely steps:

  • Turn on your TV or another device you would like to regulate.
  • Press and release the DEVICE button on your remote that’s related to the product you would like to regulate (TV, etc.). As mentioned previously, you’ll use any device with any of the labeled buttons—just remember to write it down.
  • Press the Device Button again, also because of the POWER button at an equivalent time. the facility button will close up then come on again.
  • Release both buttons.
  • Press and release the PLAY button on the remote, then wait a couple of seconds and see if the device you’re trying to regulate turns off. If so, then the remote has found the right code. If your device remains on, press the play button again and undergo the waiting and switch off process. do that until your device turns off.
  • Next press and release the REVERSE button on your remote every two seconds until your device turns back on. When it finally does, the remote has successfully looked for the proper code.
  • Press the STOP button to save lots of the code.
  • Test several functions on the remote and see if they work for your device

Leave a Comment