Toshiba DVD Player Universal Remote Codes

Would you wish to work your Toshiba DVD player together with your favorite universal remote control? but unable to do? no problem, we have the answer for it. we’ve all kinds of universal remote codes to program your remote together with your Toshiba player.

Check alsoToshiba Universal Remote Codes

Toshiba DVD Universal Remote 3 Digit Codes List

  • 112
  • 510
  • 413
  • 506
  • 902
  • 313
  • 512
  • 517
  • 613
  • 419

First of all, you would like to form sure that what codes your remote supports other you’ll simply do a manual search as we mentioned below. So allow us to mention the codes either it might be three-digit, four-digit, or five-digit, and easily enter those sort of codes one by one until your device gets programed.

1) Keycode

By using the keycode we will easily program a Toshiba DVD Player universal remote and therefore the keycode identifies the make and model of your equipment.

  • First, you would like to “Turn The Device On
  • Press the “TV” on your “Toshiba DVD Player Universal Remote
  • Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
  • Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
  • Once you’ve done this procedure, just “point your remote at the TV” then the “Press And Hold The Power” button
  • You can release the “Power Button” whenever the screen switches off

2) Programming Via Universal Toshiba DVD Player Remote Code

If you couldn’t find the key code which works for the device at that point you’ll set up your Toshiba DVD Player universal remote to look mode for the right one. Its a code in the manual which forces the remote into the search mode

  • First of all “Turn The Device On
  • Now press and hold the “Setup” button
  • Enter the (three-digit) code
  • Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off

3) Manual Setup

  • Place the “Remote Control facing To The Universal remote you would like to replace
  • Now press the “Setup Button” or “Magic
  • Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
  • Now press any of the function which you would like to “program” as an example “TV Volume Up
  • Then press And hold the corresponding key on the “Original Remote Controller
  • Finally, one among the lights will “blink” meaning it’s been saved correctly
  • Now your “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.

We hope the above methods and therefore the codes are worked to program your Toshiba DVD Player and also for your favorite remote. Those methods are used for Toshiba DVD Player remote setup.


If you are feeling good about this article then please give us a feedback, it’ll give us a boost up to enhance our site and to achieve many aspirants those that are expecting their remote codes, we also accept new universal remote codes those are working for you, please leave those codes within the below comment section we’ll forward them to the opposite users too by posting them in our site.

Leave a Comment