Contents
We have three methods to set up Huayu universal remote on our favorite device, you’ll use any of them which is suitable for your device. This one is among the best universal remotes, so we recommend you utilize this remote.
Check also: RCA Universal Remote Codes
Huayu Universal Remote Codes List
- 011, 017, 029, 032, 034, 054, 067, 069, 071, 075, 076, 077, 078, 079, 080, 081, 107, 113, 117.
Try these codes also
- 0028, 0026, 0022.
How to Program Huayu Remote
1) Keycode
By using the keycode we will easily program a universal remote and therefore the keycode identifies the make and model of your equipment.
- First, you would like to “Turn The Device On”
- Press the “TV” on your “Huayu Universal Remote”
- Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
- Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
- Once you’ve done this procedure, just “point your remote at the TV” then the “Press And Hold The Power” button
- You can release the “Power Button” whenever the screen switches off
That’s all, your TV will work perfectly now with the universal remote if your device isn’t working then attempt to repeat a similar procedure with the various code from a similar part of the reference table.
2) Programming Via Universal Remote Code Search
If you couldn’t find the key code which works for the device at that time you’ll find out your universal remote to look mode for the right one. Its a code within the manual that forces the remote into the search mode
- First of all “Turn The Device On”
- Now press and hold the “Setup” button
- Enter the “9-9-1” (three-digit) code
- Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off”
The above method might take some additional time but it’s vital to search out your key code. Once you’ve got done the above procedure your remote should be working for all the functions.
3) Manual Setup
If the above two methods can’t be helped to you then the final method is “Manual Setup”, if you configure the universal remote manually your device can work perfectly.
- Place the “Remote Control facing To the Universal remote you would like to replace”
- Now press the “Setup Button” or “Magic”
- Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
- Now press any of the functions which you would like to “program” as an example “TV Volume Up”
- Then press And hold the corresponding key on the “Original Remote Controller”
- Finally, one among the lights will “blink” which means it’s been saved correctly
- Now you’re “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.
- You have to repeat for all the buttons to program, once you’ve got done all the functions which you would like and eventually press the “Setup Button” Again to end the session.
Now operate the Huayu universal remote on your device by using the above universal remote codes. Check to check if the remote features a temporary memory that stores control information for some minutes once you need to change the batteries. Otherwise, you’ll need to reprogram the remote.
Kiran Kotte is a 25 years old Youtuber. He is a tech geek and also codes sometimes. He writes on various topics like Technology, Blogging, Web designing, and SEO. He runs various other blogs under various niches.