Are you looking forward to getting the Craig tv universal remote codes, then here is that the end to your searching, from this blog post we are getting to mention all the universal remote codes for Craig’s soundbar, so why late just check the below list and there you’ll get all kinds of codes like 2 digits, three-digit and also four-digit, five-digit codes too.
- 1 Craig Tv’s Universal Remote codes
- 1.1 Craig TV’s Universal Remote 4 Digit Codes List
- 1.2 Universal Remote For Craig Soundbar
- 1.3 Craig TV’s Universal Remote 3 Digit Codes List
- 1.4 Craig TV’s Universal Remote 5 Digit Codes List
- 1.5 Program Instructions
- 1.6 Conclusion:
Craig Tv’s Universal Remote codes
We also are providing some methods to program your favorite universal remote with this Craig tv, after finding the steps to program then use the codes to enter the program as per the methods. allow us to check the procedure too. You’ll program your cable or satellite universal remote to also control your Craig TV. Find your provider and remote within the list below and enter the TV code provided into the remote. Ask your cable or satellite provider for instructions.
Craig TV’s Universal Remote 4 Digit Codes List
- 00073, 6222, 06222, 10180, 0073, 10073, 16222, 11822
Universal Remote For Craig Soundbar
Craig TV’s Universal Remote 3 Digit Codes List
- 541, 536, 691, 662, 666, 667, 682, 009, 657, 669, 694, 532, 542, 533, 963, 038, 042, 053, 037, 161, 180, 282, 171, 064, 038, 064, 009
Craig TV’s Universal Remote 5 Digit Codes List
- 10180, 13423, 10161, 19411, 11922
By using the keycode we will easily program a Craig universal remote and therefore the keycode identifies the make and model of your equipment.
- First, you would like to “Turn The Device On”
- Press the “TV” on your “Craig TV Universal Remote”
- Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
- Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
- Once you’ve done this procedure, just “point your remote at the TV” then “Press And Hold The Power” button
- You can release the “Power Button” whenever the screen switches off
2) Programming Via Universal Craig Remote Code
If you couldn’t find the key code which works for the device at that point you’ll found out your Craig universal remote to look mode for the right one. Its a code within the manual which forces the remote into the search mode
- First of all “Turn The Device On”
- Now press and hold the “Setup” button
- Enter the (three-digit) code
- Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off”
3) Manual Setup
- Place the “Remote Control facing To The Universal remote you would like to replace”
- Now press the “Setup Button” or “Magic”
- Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
- Now press any of the function which you would like to “program” as an example “TV Volume Up”
- Then press And hold the corresponding key on the “Original Remote Controller”
- Finally, one among the lights will “blink” meaning it’s been saved correctly
- Now your “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.
We hope the above methods and therefore the codes are worked to program your Craig tv and also for your favorite remote.
First of all, you’ve got to verify the name of your remote then try all the universal remote codes which are mentioned within the above list one by one, you’ll use the methods to program your remote too, so why late start with any code until you get paired together with your Craig tv.