Marantz Blu-Ray Universal Remote Codes and How to Program Instructions

Are you one among the aspirants from those that would really like to induce the universal remote codes of the Marantz Blu-ray player? Congratulations, you’ve come to the proper place where anybody can get codes for his or her favorite remote controls. So during this blog, we are mentioning all kinds of remote codes like four and five-digit codes and also all other remaining codes too like three-digit codes.

Marantz Blu-Ray Universal 5 Digit Remote Codes

• 20539, 22414

Marantz Blu-Ray Universal 4 Digit Remote Codes

• 0689, 0732, 0666, 0688

First of all, we might wish to provide the codes list then we’ll jump into the programming methods, so allow us to start the procedure to program your remote together with your favorite Marantz blu-ray player.

How to Program Remote

1) Keycode

By using the keycode we will easily program a Marantz Blu-Ray Player universal remote and therefore the keycode identifies the make and model of your equipment.

• First, you would like to “Turn The Device On”
• Press the “TV” on your “Marantz Blu-Ray Player Universal Remote”
• Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
• Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
• Once you’ve done this procedure, just “point your remote at the TV” then the “Press And Hold The Power” button
• You can release the “Power Button” whenever the screen switches off

2) Programming Via Universal Marantz Blu-Ray Player Remote Code

If you couldn’t find the key code which works for the device at that point you’ll set up your Marantz Blu-Ray Player universal remote to look mode for the right one. Its a code in the manual which forces the remote into the search mode

• First of all “Turn The Device On”
• Now press and hold the “Setup” button
• Enter the (three-digit) code
• Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off”

3) Manual Setup

• Place the “Remote Control facing To The Universal remote you would like to replace”
• Now press the “Setup Button” or “Magic”
• Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
• Now press any of the functions which you would like to “program” for example “TV Volume Up”
• Then press And hold the corresponding key on the “Original Remote Controller”
• Finally, one among the lights will “blink” meaning it’s been saved correctly
• Now your “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.

We hope the above methods and therefore the codes are worked to program your Marantz Blu-Ray Player and also for your favorite remote. Those methods are used for Marantz Blu-Ray Player remote setup.

Conclusion

If you are feeling good about this article then please give us feedback, it’ll give us a lift up to enhance our site and to succeed in many aspirants those that are expecting their Marantz remote codes, we also accept new universal remote codes those are working for you.