Latest Vivitar Universal Remote Codes

Vivitar Universal Remote codes: Vivitar is the 8 in 1 remote and it’s the three-digit and four-digit universal remote codes, if you don’t know the remote code for your device then follow the below table and it’s all kinds Vivitar universal remote codes, so you’ll easily operate your device with this remote.

Vivitar Universal Remote Codes 

  • 5199, 3031, 0053

1) Keycode

By using the keycode we will easily program a universal remote and therefore the keycode identifies the make and model of your equipment.

  • First, you would like to “Turn The Device On”
  • Press the “TV” on your “Vivitar Universal Remote”
  • Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it’s in “Learning mode”)
  • Finally, enter the “Keycode” which you collected from the programming guide (Instructions Booklet)
  • Once you’ve done this procedure, just “point your remote at the TV” then “Press And Hold The Power” button
  • You can release the “Power Button” whenever the screen switches off

That’s all, your TV will work perfectly now with the universal remote if your device isn’t working then attempt to repeat an equivalent procedure with the various code from an equivalent a part of the reference table.

2) Programming Via Universal Remote Code Search

If you couldn’t find the key code which works for the device at that point you’ll found out your universal remote to look mode for the right one. It’s a code within the manual that forces the remote into the search mode.

  • First of all “Turn The Device On”
  • Now press and hold the “Setup” button
  • Enter the “9-9-1” (three-digit) code
  • Now hold down the “Power Button” on the remote then press the Channel up them until the device during this case your tv “Turns Off”

The above method might take some overtime but it’s vital to seek out your key code. Once you’ve got done the above procedure your remote should be working for all the functions.

3) Manual Setup

If the above two methods can’t be helped to you then the ultimate method is “Manual Setup”, if you configure the universal remote manually your device can work perfectly.

  • Place the “Remote Control facing To The Universal remote you would like to replace”
  • Now press the “Setup Button” or “Magic”
  • Then enter the “Code” (You can find this in Instruction Booklet) for manual Programming
  • Now press any of the function which you would like to “program” as an example “TV Volume Up”
  • Then press And hold the corresponding key on the “Original Remote Controller”
  • Finally, one among the lights will “blink” which means it’s been saved correctly
  • Now your “TV Volume Up” button has been saved to the Universal remote and you’ll use the quantity button.

You have to repeat for all the buttons to program, once you’ve got done all the functions which you would like and eventually press the “Setup Button” Again to end the session.

Features Of the Vivitar Universal remote

It is the 8 Device Universal remote and it can Controls up to eight devices. it’s a capacity to figure with the most major brands of TV, Blu-Ray, DVD, VCR, Cable, Satellite, Home Theater….etc This remote battery Powered by 2 AAA batteries (not included). It’s an Ergonomic, user-friendly design. Of course, it is often Replaces the necessity for original remotes.

Leave a Comment